| Product SKUs |
| MBD-X7DAE-O |
X7DAE (Standard Retail Pack) |
| MBD-X7DAE-B |
X7DAE (Bulk Pack) |
| Physical Stats |
| Form Factor |
Extended ATX |
| Dimensions |
12" x 13.05" (30.5cm x 33.2cm) |
| Processor/Cache |
| CPU |
Dual 771-pin LGA Sockets |
| Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below: |
Quad-Core Intel®
Xeon®Processor 5300 sequence (Clovertown processor) up to 2.66 GHz |
Dual-Core Intel®
Xeon®Processor 5100/5000 sequence (Woodcrest/Dempsey processor) up to 3.73 GHz |
| NOTE: Motherboard PCB revision 2.0 or above is required to support XeonR 5100 (Woodcrest) processors |
| System Bus |
1333 MHz, 1066 & 667 MHz system bus |
| System Memory |
| Memory Capacity |
Eight 240-pin DIMM sockets |
| Supports up to 32 GB 667 / 533MHz DDR2 ECC FB-DIMM memory |
| Dual branch memory bus |
| Memory must be populated in pairs |
| Memory Mirroring supported |
| Memory Type |
667 / 533MHz FB-DIMM (Fully Buffered DIMM) DDR2 ECC SDRAM 72-bit, 240-pin gold-plated DIMMs |
| DIMM Sizes |
512 MB, 1GB, 2GB, 4GB |
| Memory Voltage |
1.8 V only |
| 1.5V(AMB) |
| Error Detection |
Corrects single-bit errors |
| Detects double-bit errors (using ECC memory) |
| Supports Intel® x4 and x8 Single Device Data Correction (SDDC) |
| On-Board Devices |
| Chipset |
Intel® 5000X (GreenCreek) chipset |
| MCH + PXH-V + ESB2 |
| SATA |
ESB2 SATAII Controller |
| RAID 0, 1, 5, 10 support |
| IPMI |
Support for Intelligent Platform Management Interface v.2.0 |
| 200-pin IPMI slot (SIMLP) |
| (Optional: AOC-SIMLP-B) |
| (Optional: AOC-SIMLP-3) with 3rd LAN support |
| NOTE: KVM-over-LAN not supported - there is no DVO signal to the IPMI slot |
| Network Controllers |
Intel® (ESB2/Gilgal) 82563EB Dual-Port Gigabit Ethernet Controller |
| Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output |
| Intel® I/OAT support for fast, scaleable, and reliable networking |
| Super I/O |
Winbond 83627HF chip |
| Clock Generator |
CK410B chip |
| Input / Output |
| Serial ATA |
Six Serial ATA ports |
| Six SATA hard drives supported |
| IDE |
Single EIDE channel supports up to two UDMA IDE devices(IDE-M, IDE-S) including CF card |
| Supports UDMA Mode 5, PIO Mode 4, and ATA/100 |
| Compact Flash (40-pin connector, IDE 1, single channel) slot |
| Floppy |
1 Floppy controller; 1.44 MB, 2.88 MB |
| LAN |
2x RJ45 LAN ports |
| USB |
4x USB rear ports |
| 1x USB internal header |
| 6 total USB ports, 2.0 Compliant / 1.1 Compliant |
| Audio |
AC97 Audio |
| Keyboard / Mouse |
PS/2 keyboard and mouse ports |
| Serial Port / Header |
1 Fast UART 16550 serial port |
| 1 Fast UART 16550 serial header |
| Parallel Port |
1 ECP / EEP parallel port |
